VRAM Not released when switching from Cockpit to Cabin and BAck again

[MPO910]

@iniBuilds

Noticed in VR counted for all versions also 1.0.3 with clear installation after WASM deleted. Even my MSFS2024 got a fresh installment yesterday:

VRAM at Cockpit View = 9.5 GB (in my scenario this morning and earlier scenarios prior days)

VRAM Switching to Cabin View = 10.8 GB ! It  litterally jumped that high instantly. That is + 1.3 GB (I use Low resolutions textures in MSFS2024) FPS instantly droppes from my capped 45 to 30! 

VRAM Switching back to Cockpit = 10.8 GB nothing got released and stays this high. FPS again back to 45

VRAM Switching to Outside View = Stepwise decreasing from 10.8GB to 8.9GB within under 10 Seconds! FPS reduced to 30 and stays there! That is 15 FPS less so 30% less FPS compared to my cockpit view

VRAM Switching to Cockpit View = Jumps to 9.5 GB as initially when stared my flight, seems normal to me

Flying more then 2 hours does slowly increase VRAM IF NOT switching views between Cockpit and Outside.

It goes up from 9.5 GB to 10.5 GB in 2 hours and growths further. Paralell my FPS decreases from 45 (capped ín VARJO Software at 45) to in the 30th and does NOT recover, not even when VRAM got released while switching views from outside to cockpit again.

When switching from Cockpit to Outside again, VRAM gets released again as above descibed, FPS goes down the drain very slowly but steady and while flying hours does not recover anymore.

This is reproducable in every flight with the A350. It is NOT happening with the FENIX (4 Hour flights done) or default planes for instance.

I am suspecting as a cause:

- Navigraph activated or/and

- OIS issues or/and

- Cabin and for FPS decrease outside Textures as well not properly released

Regards

Marcus