Time compression also on the ground?

[LH4371]

Did not check with latest v0.3 but yesterday I realized with time compression on AUTO that it also kicked in on the ground during pushback and taxi. while this may speed up lining up with the active runway I found this quite cumbersome when you are wiggling around corners and along taxiways with x4 compression. maybe it could make sense to make it an option to enable time compression NOT on the ground but only when enroute?

[ekosif]

7 hours ago, LH4371 said:

Did not check with latest v0.3 but yesterday I realized with time compression on AUTO that it also kicked in on the ground during pushback and taxi. while this may speed up lining up with the active runway I found this quite cumbersome when you are wiggling around corners and along taxiways with x4 compression. maybe it could make sense to make it an option to enable time compression NOT on the ground but only when enroute?

No, I disagree with this one. Sometimes I am using it for accelerate the boarding to save some time and this is also valid for all other aircrafts like pmdg. If you don't want to use this function on the ground simply change the time compression from auto to off in the OIS. 

[LH4371]

12 minutes ago, ekosif said:

No, I disagree with this one. Sometimes I am using it for accelerate the boarding to save some time and this is also valid for all other aircrafts like pmdg. If you don't want to use this function on the ground simply change the time compression from auto to off in the OIS. 

hence I suggested to make it an option to disable compression when on the ground. 

[ekosif]

Just now, LH4371 said:

hence I suggested to make it an option to disable compression when on the ground. 

I understand that but what is the point keeping it on the AUTO if you are not going to use it at specific condition? Just switch it to Auto when you want to use it. At the end of the day, auto selection is not there to automatically enable/disable it, it's there to adjust time compression level when it is activated. 

[LH4371]

22 minutes ago, ekosif said:

I understand that but what is the point keeping it on the AUTO if you are not going to use it at specific condition? Just switch it to Auto when you want to use it. At the end of the day, auto selection is not there to automatically enable/disable it, it's there to adjust time compression level when it is activated. 

because auto does not mean like automatic if it is on anyway always. then call it ON and off and have a clickspot somewhere. but needless to discuss any further. I typically have it off now