Hello ini-Team,

it is not possible to setup the viewpoint that it matches the official documents. Therefore i think there is something wrong with the model of the glareshield. This is especially noticeable in VR.

How it should be

 

What i observe

EDDF runway width of 07R is 45m, which corresponds to the wingspan of the A300:

 

 

Default view:

If the viewpoint is set to see just in front of the center line, the flight mode annunciator on the PFD is not visible:

Is there any chance to get this fixed, as this is an immersion killer and the A300 will stay in the hangar. 

There is a nice article about Airbus seat position:

https://safetyfirst.airbus.com/are-you-properly-seated/

Best regards

Stephan

Hey there, i noticed the same. Hopefully they look into this and find a solution. @Eddie @IniSteve @richboy2307

thanks in advance.

Best regards Maverick✈️

Any answer from the INI-Team?

100% agree, In VR it's super difficult to find a correct spot to move the camera, because if you put the real one you can't see the FMA. I think it's because the glareshield isn't tilted enough; the same thing happens in the A320s and the A330 in 2024 with the glareshield. The cockpit doesn't have the correct design and Airbus did it that way for a reason. Now it's super difficult to fly these planes in VR. I don't expect iniBuilds to change your 3D cockpit, to be honest, but they could make a statement. It doesn't just happen with iniBuilds; more developers take measurements from who knows where and then in VR you realized that the plane is not accurate. great plane anywhere. 

Hello,

Team is aware of this feedback. I cannot guarantee any changes/investigation anytime soon however. 

Your effort is very much appreciated regardless. 

Thank you 🙂