Parking break memo not shown

[Balint]

Hi,

I have done some circuits in EINN with the A350-900. After about three touch and go's the fourth time I did a full stop landing and taxied to stand 39. After setting the parking break to ON, there was no PRK BRK memo shown on the Warning Display. After trying to release and set the parking break again I pressed ACCU REINFLATE button, after which the PRK BRK memo DID show on the Warning Display. Not sure if this is the intended way of it working but I very much doubt it. As the HYD's would normally pressurize the accumulator which should then not be depleted after a flight.

Please see my Simbrief flight plan and some screenshots attached.

A/C used: A350-900
Livery: SAS, SE-RSC
Sim: FS2020
Scenery: MKStudios EINN
Navdata used: Navigraph

EINNEINN_PDF_1741190017.pdf

Edited March 5 by Balint