Display type settings and GSX integration and other issues

[Soso330]

Hello, i've found a couple of issues. this was with the -900, haven't tested the -1000 but i guess they both run on the same code.
Tested these things out twice with almost the same results.

Display type settings in the OIS change by themself.
I selected the "new" type of displays and after a session restart it showed that the "old" displays were chosen on the OIS, but the "new" ones were the ones that was actually showing, after another session restart they had also changed to the "old" just like what the OIS settings showed.

GSX integration issues.
First issue was that in order to make the GSX menu show up on the OIS on a session or sim restart i have to disable and then re-enable the "GSX Integration" setting even though i left the session with that setting enabled.

Second issue was that when loading the plane with that GSX integration was that it loaded the cargo holds successfuly but added passengers aswell(about 8 of them), and when it started loading the passengers it also started to load extra weight in the cargo holds even though the cargo loading was already finished and the cargo doors were closed. Also it only loaded 140pax instead of the 318pax that was planned through simbrief using simbriefs own inibuilds A350 config.

First test
140pax instead of the planned 318 -about 8 of them was before pax loading 
4.1tons instead of the planned 8 -before pax loading
10.8tons instead of the planned 8 -after pax loading

Second test
140pax instead of the planned 318 -about 8 of them was before pax loading 
4.1tons instead of the planned 8 -before pax loading
21.9tons instead of the planned 8 -after pax loading

Third issue was that in that same "loadsheet" tab on the OIS the "totals" never updated no matter how much cargo or passengers GSX added.

Pax weights are only shown for First, Fwd Eco and Aft Eco, weights doesn't show under Premium Eco but pax amount shows on it.

And for some reason during the first test door 2L didn't open for GSX but during the second test it did.

Also during the second test the %ZFWCG on the loading tab went to 0 and stuck there.

This is in MSFS2020

Kind regards

[Soso330]

And right after starting this thread the sim froze for a minute or two and when it unfroze itself all of the GSX vehicles were gone and even the GSX menu on the OIS were gone, after disabling and activating the "GSX Integration" on the OIS and selecting "operate stairs" twice they came back.

I know that this sounds like a GSX issue but i have flown with the FBW A380 countless times over the last couple of months and this issue was a first for me.