richboy2307 Posted February 23 Posted February 23 SYSTEM OVERVIEW On the iniBuilds A350 Airliner for MSFS 2024 you can use the Flight Attendant Panel (FAP) to manage and monitor: Cabin Lighting Avionics Bay Lighting Cargo Bay Lighting Cabin Temperature Cabin Doors Water and Waste Tanks Capacity / Status There are a total of 2 touchscreen FAPs installed on the aircraft located at FWD galley near door L1 AFT galley near door L4 (Click here to enlarge image) CABIN STATUS The Cabin Status page gives you a quick overview of the Lights, Temp and Door status of the aircraft. Buttons & Controls Cabin Ready: Press to send the CABIN READY ECAM alert to the cockpit. Press again to reset. Lights Graphic: Press to access the Lights page. Temp Graphic: Press to access the Temperature page. Door/Slides Graphic: Press to access the Doors page. Waster/Waste Graphic: Press to access the Water/Waste page. (Click here to enlarge image) LIGHTS The Lights Status page allows you to quickly toggle light modes for all or individual zones. Buttons & Controls Night Mode: Sets CABIN to the LOW DIM state Main On: Sets CABIN to the BRIGHT state Zones: Allows you to set the lighting of the Cabin, Avionics Bay or Cargo Bay zone individually. The current status of that zone is shown in text below it (Bright , Medium Dim, Low Dim) Local: Allows you to set the desired status of the selected zone (highlighted in green) To manually adjust the brightness of a selected zone Click on the desired zone button (Cabin / Avionics Bay / Cargo Bay) The active zone will be highlighted in green Click on the desired status for the selected zone in the Local section (Bright / Medium Dim / Low Dim) The current status of that zone is shown in text below it. (Click here to enlarge image) TEMPERATURE The Temperature Status page allows you to manually adjust the target temperature for the cabin. Buttons & Controls Zones: Allows you to view the temperature of the Zones A, B or C individually. The current temperature of that zone is shown in text next to it. Local: Allows you to set the desired temperature target for all the zones via the +/- buttons. To manually adjust the temperature of a selected zone Click on the + or - button to set the target temperature for the selected zone in the Local section a. The current target value is shown by the number and graphic scale in the Local section. b. The actual current temperature of each zone is shown on the number in the Zones section. (Click here to enlarge image) DOORS/SLIDES The Doors Status page allows you to open/close doors and monitor their current status. Buttons & Controls Door 1 Left: Click on the door icon to open/close the door Door 2 Left: Click on the door icon to open/close the door Door 3 Left: Click on the door icon to open/close the door Door 4 Left: Click on the door icon to open/close the door Door 1 Right: Click on the door icon to open/close the door Door 2 Right: Click on the door icon to open/close the door Door 3 Right: Click on the door icon to open/close the door Door 4 Right: Click on the door icon to open/close the door The legend on the left shows what status is reflected by each of the colours. (Click here to enlarge image) WATER/WASTE The Water and Waste Status page allows you to manage and monitor the status of the respective tanks. Buttons & Controls Refill Water: Sets the Water tank to 100% capacity Empty Waste: Sets the Waste tank to 0% capacity The Waste tank fills up, whilst the Water tank drains throughout the duration of your flight. The Water and Waste Quantity graphic reflects the current % value of the tanks. (Click here to enlarge image) Vrishabh Sehgal ( @Richboy2307 ) Community Team Member & Tester iniBuilds Ltd. | inibuilds.com
Recommended Posts