A 300 premium Engine 1 no fuelflow

[KaiUweWeiss]

Maybe I'm too stupid a little bit: if I start the engines I use engine 1 as first. After its spooled up successfully, I start engine 2. Suddenly engine 1 goes down, I can't restart it anymore, there is no fuelflow it seems. I don't know why, switching X-Feed doesn't help. Please look at my screenshots, maybe you can see what I've done wrong. In FS2020, the same plane, verything works very well.

Edited Tuesday at 11:57 AM by KaiUweWeiss

[KaiUweWeiss]

I figured out that this situation happens if I push back the engine start button to the middle. If I left it at start the engines doesn't spool off. In this situation APU-bleed remains permanently. Perhaps spooling off the engines happens due to bleed? It doesn't matter: either the start button or the bleed situation is responsible for engine 1 spooling down.

In this configuration the engine doesn't spool down and works properly. The same situation in FS2020: there is the engine start button in the middle and APU-bleed off.

Edited Tuesday at 03:52 PM by KaiUweWeiss

[moppi]

Do you use by chance a Bravo throttle? One of the default bindings was preventing engine 1 to start correctly in my case. Once I had deleted all bindings except throttle axis, everything worked as expected.

[KaiUweWeiss]

Thank you, I'lltry that.

[ChrisRee]

Hi,

I have the same problems. I use the Bravo throttle. There are no bindings on any axes. Cont Relight prevents the engines from shutting down immediately. After takeoff at the latest, I have a failure on engine 1.

It is always Engine 1

I flew the A300 for many hours in MSFS 2020. I can't remember any problems like that.

[Eddie]

Hi there,

If any of you are using BeyondATC, please make sure you update to the latest version available and try again. We identified some kind of conflict with the version prior to the latest and it seems it has been resolved now on BATC's end. 

Thank you 🙂