I attempted today to map the FCU knobs for altitude and heading to a couple of encoder knobs on my controller, with the Axis and Ohs scripts I downloaded from flightsim.to a while ago and work fine for some other commands I have mapped. 

However, for these two FCU knobs, the increase and decrease buttons do not work at all. I thought maybe it was because they are encoders, but trying to map them to momentary switches didn't produce any solution - the knobs just sit there idle.

There are two different AAO scripts out there for the A300 on flightsim.to and I tried both sets of scripts, but neither of them would work.

I am using the A300 with AAO (and a VRi MCP Combo connected) and SD/SD+ working fine. I am one of the creator of the profiles. What exactly is the issue? Do your rotaries produce inputs in AAO for both directions?

Edited October 26, 20241 yr by ChrisPUA320

It might be because the knobs aren't animated - I tried the default inputs (i.e., those not created by a third-party profile), and those work fine, although the knobs will not rotate.