Jump to content

Altitude selection MCP


cconesa

Recommended Posts

Could someone be so kind to tell me if there is a way to select the altitude in the MCP in smaller units than 1000 feet so that I can select a level such as 15,400 ft, etc. At present I can only select altitudes in 1000 feet increment/reductions.

Thank you.

Link to comment
Share on other sites

Press on the ALT knob to enter 100s mode then press again to return to 1000s mode.  This is the knob you turn left and righ to change the altitude. 

  • Thanks 1
Mark "Crabby" Crabtree AAL311 | PHL
I7-9700KF | 2070 Super | Honeycomb Alpha/Bravo | MFG Crosswind

logo_130208.png

Link to comment
Share on other sites

18 minutes ago, cconesa said:

Thanks crabby!, was that even in the manual?. I would have never guessed that’s what you needed to do

Honestly, the only part of the manual I looked at was the EFB section.  This came from my A310 pre-release reading of the FCOM.  The A310 and A300 have almost identical operation, if not identical.  So I honestly don't know if it is in the INI manual or not. 

Edited by Crabby
Mark "Crabby" Crabtree AAL311 | PHL
I7-9700KF | 2070 Super | Honeycomb Alpha/Bravo | MFG Crosswind

logo_130208.png

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...