
ShogunAssassin
-
Posts
6 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Posts posted by ShogunAssassin
-
-
Hello Inibuilds! I would just like to raise an issue which is that the Enroute chart in OIS is not loading again while in flight. This issue was resolved in the past updates but it has resurfaced once again. Only the standard map loads while the IFR night and day charts never load again while in flight. This is for msfs 2024 btw, not sure for 2020.
-
Can confirm this issue. Attached is video of proof. I was flying the a350-1000 in this video.
-
1
-
-
I’m also experiencing this issue specially as to estimated time. I’m not sure if the CDA implementation messed up my arrival time or this was already an issue which I failed to notice in the previous versions but as you can see in the first screenshot (Screenshot 1) I have attached to this comment, the plane estimates me at Flaps 2 by 8:12 and at LL613 at 8:15 UTC. But as you can also see, the current UTC time is 7:42, and I am 1 nautical mile away from the flaps 2 marker shown on the ND and roughly 3 nautical miles from LL613. It’s hard to believe that it would take me 30 more minutes to reach a point which is already only 1-3nm away from me. After passing LL613, the UTC time changed and showed beside it was the time I actually passed it, which was 7:42 (Screenshot 2). But the estimated arrival time changed from 8:15 to 8:17, yet I was already by the gate at 7:55 UTC. So there is probably something wrong with how the plane estimates its arrival on certain points specially upon final approach and landing.
-
1
-
-
The side stick animation only seems to respond when you move your own sidestick to the extreme ends, like full left and full right or full up and full down. The video above is me doing the normal flight control check movements on my own sidestick and this was the result in sim.
-
3
-
-
Hello Inibuilds team!
I would just like to inform you that as of v1.8, “Flare” and “Roll Out” does not appear when manually landing the plane. I saw that it worked in the previous update but now it would not appear as can be seen in the attached media file. I’m not sure if it should appear in this kind of approach, which is an RNAV done through FLS in this case. This is also VTBS 20R if you guys are curious.
If it shouldn’t appear, it is my bad then, but another question, should G/S and LOC even show up after F-LOC and F-G/S reverts after landing? Because I did not even set the frequency for an ILS and it auto-tuned to the ILS frequency on 20L upon landing. Thank you!
Displays flashing when switching from external view mode
in Modelling & Texturing
Posted
Hi Inibuilds! There seems to be a loading issue with the cockpit when you switch from external view mode after a few hours of flight. The video attached is me almost 7 hours in for a flight and after hanging around atleast 10-15 seconds in external view mode, when you switch to cockpit view the flashing happens and after a few seconds, the cockpit loads. Had to cut the video due to file size constraints.