Jump to content

geckuz

Member
  • Posts

    18
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

geckuz's Achievements

2

Reputation

  1. Since v 1.0.5 when disconnecting A/P on final via sidestick, Master warning starts blinking and beeping and ecam message comes up. What was changed from previous version? Or is it a regression bug?
  2. So, to share my personal experience on the topic. I previously had an older CPU and low FPS, and input lag was a nightmare on this plane. Now I moved to an i9 14900k and raised settings just a bit, I have good frames and no more input lag.
  3. Steps to riproduce: Create a pilot waypoint, do not store. Go to the router, input the waypoint, realize you did not store It, go back to the waypoint Page and click store.
  4. Was trying to inser pilot waypoint ETP1 as per attached route. When clicked Store Waypoint it crashed. Navigraph airac2503 A350-900 FS2020 i9 14900K rtx 3060 32GB RAM OMDBVRMM_PDF_1742457740.pdf
  5. geckuz

    WASM crash

    @richboy2307 please find attached the flightplan. I was preparing arrival for RWY 27 at VAAB, I insterted the rwy 27, ILS Y, STAR POKON2A, in both TRANS and VIA EXOLU, I went to TMPY F-PLN, then I switched to plan mode in EFIS to review the route, and I noticed that EXOLU in both VIA and TRANS was conflicting, so I clicked UNDO in the MCDU and got all the screens frozen and when I checked the log and there was that WASM error. OMDBVABB_PDF_1742123561.pdf
  6. geckuz

    WASM crash

    Clicked UNDO on TMPY FLT PLN, everyting frozen afterwards. V1.0.4 WASM: Exception c0000005 in gauge EFIS in module vfs://inibuilds-aircraft-a350/SimObjects/Airplanes/inibuilds-aircraft-a350-900/panel/inibuilds-A350.wasm
  7. @richboy2307 Vrishabh sorry for delay. Here it is. Navigraph airac OKKKOMDB_PDF_1741077708.pdf
  8. geckuz

    MCDU click lag

    Do you guys have fsrealistic? That One was causing the issue for me
  9. You have to turn both the PA knob and the PA button
  10. Hi, after setting up arrival in OMDB Rwy 12L via REREK VUTE3B FMGC and ND shows weird UTC times and vertical profile is not showing on ND
  11. Msfs2020 Is the same, It s not the sim it's the plane
  12. you turn right, it turns half a second after the input, you release the stick it keeps turnig for half a second, so you turn the opposite direction to compensate, and it does the same, and you end in a rollercoaster.
  13. Well, what people is describing Is input lag, and It has nothing to do with sensitivity. I have that issue too and controls are set as you suggest. Even if I set a 10% curve on sensitivity I should not get an input delay, I should Just move the Stick more. Can you please investigate? It Is a Nightmare to fly an otherwise beautifil aircraft manually.
  14. Same here, MSFS2020 no charts no weather
×
×
  • Create New...