Wingtip2802

The Tiller is the Name for the Steering Wheel to steer the Aircraft on the Ground. Would you minde to let me know what Stings you have for it in the EFB? Thank you Joachim

Hi and thank you for the quick replay. As I mentioned in my post, when I try to calibrate my TCA Throttle and I go step by step, first full revers, revers Idle, Idle and then TOGA all as per the instruction. Then I move the Throttle to Idle and the N2 is going up and down about 10-15% and the Reverser Light above the Engine Indication goes on. Going to the outside View you can see the T/Rs open and closing a bit constantly. The other Problem I have it the Tiller. No matter how I adjust the Tiller and Rudder options in the EFB Setting Page( Auto Tiller Disconnect ON or OFF and the Rudder Control Tiller ON or OFF. I can not get the Tiller Axis to work. If I use the Rudder Pedals the Steering via the Rudder works fine. Extra Info: I also fly the Fenix A320 with a different Profile and all works fine, then I created a new Profile just for the Ini A300, no help. I updated the TCA Firmware to the newest Version after it did not work with the old one. I real hope you can lead me in the right Direction and get this Problems fixed. Brgds and thank you Joachim

I am not able to calibrate my Thrustmaster TCA Throttle. Tried all the tips in the MSFS Forum and in You Tube but nothing works for me. Also it is not possible to use a Tiller, tried all settings in the EFB, nothing works. Is there any Work from Inibuilds in progress or are we on our own? Any hint to fix the Problem is most appreciated.

Gentleman, I did try it again today and I noticed the A/P starts acting up at the end point of a SID. I startet from EDDB RWY 07R with the LUROS1Q Dept. That's a long SID and 3/4 of the distance I reached 20.000ft and all was normal. Exactly when I reached the last waypoint of the SID (LUROS) that was the last turn the A/P made. After that the plane did not respond to any HDG input nor to the programmed flight plan. So it seams he flies the SID's perfectly but has problems with the flight plan. This time I entered the F/P via Simbrief but it does not make any difference, the very first flight I made with the 310 I entered the F/P manually.

OK, I was hoping that will fix it.

Question, did you update the 310 in the Marketplace? I did but no time to check if it will fix the issue.

I have the exact same problem. Can't figure out what it causes that behavior.