FAQs

Here you’ll find the manual for the Microsoft / IniBuilds Fokker F27 F27_MSFS_Manual v0.4.pdf

Microsoft / iniBuilds - F27 Simbrief Profile: https://dispatch.simbrief.com/airframes/share/347385_1772551834373

The following section is intended to supplement the Simplified Procedures or in-simulator Checklist. General operating guidelines are provided along with speeds and power settings to be applied per flight phase. Engine Start The port engine is started first, followed by the starboard engine. Select the port engine. Starter master switch: START Push and hold the STARTER button until the red light above illuminates, then let go of the switch. When the RPM reaches 1200 to 1500 RPM: HPC lever to the LOCK-OUT position. Repeat the procedure for the starboard engine. After Start Set the starter master switch to SAFE.…

The Microsoft / IniBuilds F27 is equipped with a dedicated DME Receiver that can be tuned via the Lower Overhead Panel to display DME Unit readouts on the main instrument panel. DME Radio Tuning The DME Receiver is tuned via the the knobs on the Lower Overhead Panel. The active frequency is denoted with a DME decal above the frequency display window on the right. DME Unit Operation The DME Unit on the Main Instrument Panel has a knob that toggles the digital display to show three distinct, real-time navigational data points relative to a DME station: DME Miles (NM): The straight-line "slant range" distance from the aircraft to the groun…

The Microsoft / IniBuilds F27 is equipped with 3x COM radios, 2x NAV Receivers, 1x DME Receiver, 2x ADF Receivers. The COM1/NAV1 radios are always tuned via your chosen GPS Unit, while all other radios are controlled via the Lower Overhead Panel. GPS Unit The COM1/NAV1 are always controlled via the GPS unit controls. You dial the standby frequency and then swap it to active. On the GNS 430, press the PUSH C/V button to toggle between COM1 and NAV1 radio tuning functions. On the PMS / TDS GTN 650, press the right knob to swap between COM1 and NAV1 radio tuning functions. Lower Overhead Panel (Radio Panel) The COM2/3, NAV2, DME an…

The Electronic Flight Bag (EFB) on the Microsoft / IniBuilds F27 can be used to display Navigraph Charts and Enroute Map overlays. This feature requires a Navigraph acccount with an active paid subscription that you can link via the EFB Options page. Connecting Your Navigraph Account Press the Options button on the EFB sidebar Scan the QR Code or click the OPEN IN BROWSER button to login to your Navigraph Account. Note: You can press the REFRESH CODE button in case your code expires. Follow the on-screen instructions in your browser to complete the authorization. Return to the EFB. Upon successful connection, you will be s…

The Electronic Flight Bag (EFB) on the Microsoft / IniBuilds F27 can be used to swap between WT GNS430 (Default), PMS GTN 650 (Payware) or TDS GTN 650 (Payware) GPS units on the glareshield. Swapping GPS Units Press the Options button on the EFB sidebar. Select your desired GPS via the buttons under GNSS SELECTION section at the top of the screen.

The Microsoft / IniBuilds F27 is equipped with a three -axis autopilot, with its control panel located in the pedestal. Autopilot Controls Autopilot master Autopilot control panel Altitude alerter Autopilot heading mode knob Note: only the Captain’s heading knob controls the autopilot heading mode Autopilot Control Panel Altitude hold Heading hold mode Nav 1 / GPS hold mode Back course hold mode ILS approach mode Pitch attitude selector Note: place cursor over the switch to see the selected pitch target in degrees. Angle of bank limiter Note: place cursor over the switch …