Hi everyone,

When I export a flight plan from SimBrief for the iniBuilds A380 and load it into the aircraft, I can select the runway in FMS1, but the SID and Transition options only show "NONE".

I don't have a Navigraph subscription and I'm using an older AIRAC cycle. However, I don't have this issue with other aircraft such as the iniBuilds A350, PMDG aircraft, or the Fenix, where SIDs and transitions are available.

Is this currently normal behavior for the A380, or should I still be able to select SIDs and transitions in FMS1?

Thanks for any advice.

no one has this issue?

Hi,

Sorry for the late reply. Much of the team has been travelling for a flight sim event.

If you are not using Navigraph, the aircraft should default to using the native sim airac.

Can you confirm this is happeneing on every approach, or only certain airports?

Thanks!

This is happening every airport , thank you.

1 hour ago, johnliem said:

This is happening every airport , thank you.

Thanks. Can you confirm both the sim and aircraft are running on the same AIRAC?

About your last reply, where can I see that? And as I mentioned above I do not have this issue with other aircrafts. Even with A350, at the moment I am at the office, so I can not check about the AIRAC one thing I know that I do not have the newest AIRAC.

33 minutes ago, johnliem said:

About your last reply, where can I see that? And as I mentioned above I do not have this issue with other aircrafts. Even with A350, at the moment I am at the office, so I can not check about the AIRAC one thing I know that I do not have the newest AIRAC.

Ok, thanks. I will clarify with the team in the morning and hopefully provide you with more info.

Thanks again for your patience!

Thanks.

Thanks for the update. I appreciate your help and will wait for further information from the team.

In the meantime, I have another question. Could you please tell me why this screen/monitor is not active? Please see the attached picture and the area indicated by the yellow arrow.

Thank you.

31 minutes ago, johnliem said:

Thanks for the update. I appreciate your help and will wait for further information from the team.

In the meantime, I have another question. Could you please tell me why this screen/monitor is not active? Please see the attached picture and the area indicated by the yellow arrow.

Thank you.

Hi,

You need to turn the OIS on now. I'll attach a screenshot of where to find that!