Installed the new EGKK scenery and the multi jetway does not work, either using the EFB or GSX.

Any ideas please?

The jetway does not move at all.

TIA.

I had it working after a EGKK uninstall/reinstall along with the multi jetway tool, then a PC restart. I tested it with the synaptic A220 but only at the heavy 558 gate !

With the A350-900, as GSX was in remote control, I got only one jetway spawned at 558 gate... Did not have the time to try again !

So any tips from Ini to get it working each time would be great !

Hi everyone,

Please make sure that after updating the scenery, you also reinstall the GSX profile through the iniManager.

Everything is working perfectly fine on my end!

Thanks!

I have the same problem and i did everything you said twice

can someone pls help

ive been sitting here for 10 min and it says the same thing

help pls❤️

5 minutes ago, Aiden Epstein 223 said:

I have the same problem and i did everything you said twice

can someone pls help

ive been sitting here for 10 min and it says the same thing

help pls❤️

and its the only gate where the jetway dosnet work

On 8/22/2026 at 5:02 PM, Aiden Epstein 223 said:

I have the same problem and i did everything you said twice

can someone pls help

ive been sitting here for 10 min and it says the same thing

help pls❤️

Hi,

To attach multiple jetways, you’ll need to use the iniBuilds Multi-Jetway Tool, which is located on the default tablet. You can access the tablet by pressing TAB on your keyboard.

Using the tool should prompt multiple jetways to attach to the aircraft.

I just tested this again on my side, and everything is working as intended.

Hope this helps, thanks!