Default cockpit camera position too low causing bottom of HUD to not be visible

[BillyBobJoe0987]

The default cockpit camera position in this aircraft is too low. Because of this the bottom part of the HUD, specifically the ILS info, the QNH, and the lateral positioning diamond, are not visible as they would be located below the HUD. You can also see the cockpit camera is too low by looking at the three alignment balls on the center pilar. The bottom of the white ball is slightly visible but if the camera position was correct it would be completely hidden. This happens in both the -900 and the -1000. The camera is also turned slightly to the right but only in the -900.

[foliainfx]

12 minutes ago, BillyBobJoe0987 said:

The default cockpit camera position in this aircraft is too low. Because of this the bottom part of the HUD, specifically the ILS info, the QNH, and the lateral positioning diamond, are not visible as they would be located below the HUD. You can also see the cockpit camera is too low by looking at the three alignment balls on the center pilar. The bottom of the white ball is slightly visible but if the camera position was correct it would be completely hidden. This happens in both the -900 and the -1000. The camera is also turned slightly to the right but only in the -900.

I requested that iniBuilds move the camera to the proper position months ago, they didn't do anything about it, so you'll have to adjust it manually.

[BillyBobJoe0987]

I would hope they would now listen so everybody can see the entire HUD without knowing to move the camera but realistically they will probably just ignore this.