I have got one outstanding issue to resolve to complete programming my WinWing FCU using SPAD.NEXT. Title says it all, I cannot find the variable that displays the FPA value. I even checked a Mobiflight module for A320neo but they seem to have created their own variable (INI_FPA_DIAL) which doesn't exist outside of mobiflight.

Thanks In Advance

On 11/12/2024 at 7:43 PM, muskysim said:

I have got one outstanding issue to resolve to complete programming my WinWing FCU using SPAD.NEXT. Title says it all, I cannot find the variable that displays the FPA value. I even checked a Mobiflight module for A320neo but they seem to have created their own variable (INI_FPA_DIAL) which doesn't exist outside of mobiflight.

Thanks In Advance

Hi, is there any reason you're using SPAD.Next over the default WinWing software to configure your FCU? The A320neo V2 should be supported natively when using their software.

 

11 minutes ago, JoshF said:

Hi, is there any reason you're using SPAD.Next over the default WinWing software to configure your FCU? The A320neo V2 should be supported natively when using their software.

Yes, I have a lot more hardware such the HC Bravo throttle and also the WinWing Airbus Sidestick and they have a lot of buttons that I could not program using SimAppPro and when this software was running it was conflicting with SPAD.NEXT particularly with the WinWing Airbus Throttle. So thats why I went this way. Anyway I don't know why I couldn't see the (INI_FPA_DIAL) LVAR cause all of a sudden in was there and it is an internal lvar of the A320 neo so I was able to complete the FCU in SPAD.NEXT

You raise a good point though, if I could have manually specified what Winwing products I wanted SimAppPro to drive ie Only the FCU and not the throttle I would have been good to go.