Hello IniBuilds team,

I’m reaching out for some help with a sudden issue on the A300. I’ve been using this aircraft for over a year without problems, but lately, I haven’t been able to start Engine #1. It stops spooling up at around 25/26% N2 and won’t reach full idle. I’ve double-checked my start-up procedure and settings but can’t seem to figure out what’s causing the issue.

Here’s what I’ve attempted so far:

• Verified that fuel flow is on and the fuel valve is open.
• Checked bleed air system and APU output for sufficient air pressure.
• Tried using cross-bleed from Engine #2, which starts normally, to see if that would make a difference.

Any ideas on what might be causing Engine #1 to stall at 25% N2, or any settings I should check or adjust to fix this? Any guidance would be appreciated!

Thanks in advance for the help!

Hi Maverick!

Apologies for the late reply. Must've missed this post. Anyway! Try to check the maintenance options, to see if it might be a wear and tear issue. If not, try to run A300 without any addons to rule out any potential conflict. Additionally, you can try to clear the work folder: 

Steam: %APPDATA%\Microsoft Flight Simulator\Packages\inibuilds-aircraft-a300-600

MS Store: %LOCALAPPDATA%\Packages\Microsoft.FlightSimulator_8wekyb3d8bbwe\LocalState\Packages\inibuilds-aircraft-a300-600

The simulator will recompile those files (same as first time launch) next time you load the a320neo.

Thank you