A300 Engine #1 Won't Start – Stalls at 25/26% N2

[Maverick3461]

Hello IniBuilds team,

I’m reaching out for some help with a sudden issue on the A300. I’ve been using this aircraft for over a year without problems, but lately, I haven’t been able to start Engine #1. It stops spooling up at around 25/26% N2 and won’t reach full idle. I’ve double-checked my start-up procedure and settings but can’t seem to figure out what’s causing the issue.

Here’s what I’ve attempted so far:

• Verified that fuel flow is on and the fuel valve is open.
• Checked bleed air system and APU output for sufficient air pressure.
• Tried using cross-bleed from Engine #2, which starts normally, to see if that would make a difference.

Any ideas on what might be causing Engine #1 to stall at 25% N2, or any settings I should check or adjust to fix this? Any guidance would be appreciated!

Thanks in advance for the help!

[Eddie]

Hi Maverick!

Apologies for the late reply. Must've missed this post. Anyway! Try to check the maintenance options, to see if it might be a wear and tear issue. If not, try to run A300 without any addons to rule out any potential conflict. Additionally, you can try to clear the work folder: 

Steam: %APPDATA%\Microsoft Flight Simulator\Packages\inibuilds-aircraft-a300-600

MS Store: %LOCALAPPDATA%\Packages\Microsoft.FlightSimulator_8wekyb3d8bbwe\LocalState\Packages\inibuilds-aircraft-a300-600

The simulator will recompile those files (same as first time launch) next time you load the a320neo.

Thank you