V1.0.1 TACAN in DME gauge

[mgr]

Hi,

Great you put in the TACAN receiver in the cockpit!!!   The switch between VOR/ILS and TACAN works and functions.

Only the RMI does not show the bearing to the TACAN like it suppost to do?

Also the second digit of the TACAN is very hard to read from pilots position, the tooltip is also blank.

Marcel

 

[IniSteve]

8 hours ago, mgr said:

Only the RMI does not show the bearing to the TACAN like it suppost to do?

The RMI is tied only to the NAV radio so you wont get bearing information in TACAN Mode.

The tooltip for the smaller digits is integrated into the main one. If you grab and rotate, it will change as you move into the 3-digit channels.

[mgr]

16 minutes ago, IniSteve said:

The RMI is tied only to the NAV radio so you wont get bearing information in TACAN Mode.

Believe in real-life one needle is couple to NAV1/ILS and the other needle to the TACAN mode.  Also in the classic panel you only have NAV1 and TACAN.
Would nice to have this functional. 😇

About the tool-tips, fear i use this the legacy mode. 
Is it possible to also include a "old style" tool-tip with the current value?  Would also be handy for the other controls of the COM1, NAV1 and transponder.

[IniSteve]

The lack of RMI coupling is due to a sim limitation with the TACAN system.
 

The Nav 2 unit is in the rear cockpit. 
 

Our products are designed to the official sdk which mandates use of the modern/lock control system but we’ll see if we can revise the legacy tooltips.