Donforcefeedback

Thank you for replying, I have cleared the WASM folder and had no issues when retrying the EGLL to EGPH route, the only other difference is that I realised after landing today is that I used the PW cargo model and not retried the GE cargo model where I had the issues. I'll give it another try tomorrow with the GE variant but hopefully clearing the WASM folder has fixed things. If WASM affects both aircraft engine variants equally then this could be a good sign. I'll give a quick update later this week after more testing just to be sure. Many thanks again!

Hi, Had a wasm crash usually when I'm about to land at an airport. Specifically around turning off AP1 (autopilot) before landing. Unfortunately I don't have a video, but it seems to happen when trying to disengage the autopilot around the decision altitude above the runway. Aircraft is fully set for landing (gear down, max flaps, autobrake set to medium, brake fan on, armed spoilers, land selected on the MCP) I was aware of the same crash when disengaging the autopilot yesterday so turned off ap2 first, still fine (switch moved), then tried to turn off ap1 however the switch didn't move, but i could use the joystick to fly the plane onto the runway. Throttles were fixed into position so had to manual brake and pull off runway with around 40/50% thrust. I did have control of the throttles beforehand as I had disengaged the auto throttles 10 seconds before i went to turn off the autopilot. Outside of physical joystick control (no cockpit or model animation) i also had rudder brakes and parking brake control. Flaps, spoilers and all buttons became pretty much unresponsive (though when clicking on the parking brake, that could engage and release despite no cockpit animation happening). I believe in my flight yesterday it happened again when coming into land despite flying into a different airport. Yesterday i flew EGSS to EGPH and today flew EGPH to BIKF. Both have payware scenery. Aircraft: A300-600 Premium Simulator: FS2024 WASM Error: WASM: Error during Systems_gauge_update execution. Error code : 0xc0000005 Specs: CPU: AMD Ryzen 7 9800X3d, GPU: AMD Radeon RX 9070 XT (XFX SWIFT), RAM: 96gb DDR5 6000mhz (cl30)