Chrisinhkg

Engine Failure during initial climb (Selected ENG 2 Failure after V1) - Selected TOGA (as FLEX Take-off) - FMA indicates TOGA however GA SOFT indication on Engine Display, with thrust still at FLEX, this is incorrect, and it should have increased to TOGA when selected. - At THR RED (altitude) Thust increased as it changed to TOGA from GA SOFT - Acceleration from engine failure (pressing ALT) - On reaching Green Dot – should show the thrust selected i.e. MAN TOGA with flashing LVR MCT underneath and this is where you would normally continue the climb and select MCT– BUT it does nothing. - Limitations – o APPR & LDG – should also show § LDG DIST AFFECTED § GA THR : TOGA ONLY STATUS page with Engine 2 shutdown o Under APPR & LDG should also show GA SOFT in Amber - Activating approach and selecting Flaps 1 – unable to remove STATUS - GO-AROUND – FMA shows TOGA but Engine Display only shows thrust at GA SOFT (it should not be available with ENG inop) and should be in line with actual thrust level position. Changes to TOGA again at THR RED - Managed Speed increases when starting GO-AROUND more than it should, should stay at Vapp (speed at start) and up to max VLS +15kts - STATUS – unable to remove after GO-AROUND until clean. Insert Next WPT You should be able to put in multiple ways – doesn’t work correctly - Select a waypoint that you want to reference – select next waypoint o Type + or – and the distance that you want .i.e. -10 or +15 (as long as there is enough distance either before (for - ) or after ( for +) and the waypoints in the FM it will work same for o Waypoint name + or – distance .i.e TESLA/-10 or TESLA/+10 o No reference waypoint in database from what you typed in – brings up create new waypoint. Many other bugs, but this is a start.